[runfarm]
runfarmtag=command-runfarm

f1_16xlarges=0
m4_16xlarges=0
f1_4xlarges=0
f1_2xlarges=1

runinstancemarket=ondemand
spotinterruptionbehavior=terminate
spotmaxprice=ondemand

[targetconfig]
topology=no_net_config
no_net_num_nodes=1
linklatency=6405
switchinglatency=10
netbandwidth=200
profileinterval=-1

# This references a section from config_hwconfigs.ini
# In homogeneous configurations, use this to set the hardware config deployed
# for all simulators
defaulthwconfig=firesim-boom-singlecore-no-nic-l2-llc4mb-ddr3

[tracing]
enable=no

# Trace output formats. Only enabled if "enable" is set to "yes" above
# 0 = human readable; 1 = binary (compressed raw data); 2 = flamegraph (stack
# unwinding -> Flame Graph)
output_format=0

# Trigger selector.
# 0 = no trigger; 1 = cycle count trigger; 2 = program counter trigger; 3 =
# instruction trigger
selector=1
start=0
end=-1

[autocounter]
readrate=0

[workload]
workloadname=command.json
terminateoncompletion=yes
suffixtag=

[hostdebug]
# When enabled (=yes), Zeros-out FPGA-attached DRAM before simulations
# begin (takes 2-5 minutes).
# In general, this is not required to produce deterministic simulations on
# target machines running linux. Enable if you observe simulation non-determinism.
zerooutdram=no
